Involute Spline Gear Hob with DIN 5482
2021-11-09 13:23:47
jiangxingTools
3390
Involute Spline Gear Hob with DIN 5482
hobs for spline shafts with involute flanks previously DIN 5482
30° pressure angle
quality grade A to DIN 3968
single start, right-handed
with keyway
For cutting spline shafts as per ANSI, DIN Standards, Involute Spline hobs have a stud tooth depth for cutting all types of standard and non-standard involute splines where as straight spline hobs are used for cutting parallel splines and are manufactured in single or multi start design with pressure angles 20°, 30°, 37.5° and 45°.
相關(guān)文章
-
Taper Shank Type Shaper Cutters with DIN 1828
Taper Shank Type Shaper Cutters with DIN 1828These shaper cutters are 20° PA, non-topping finishing... - PA30° DIN5480 Involute Spline Hob Cutter with Module m6
- Carbide Hob
- Hob Resharpening
- PA20° Profile DIN3972 Standard Pre-grinding Gear Cutter Hob with Module m3.75
- DIN3972 Standard Module Involute Gear Hob Cutter
- PA30° DIN5480 Involute Spline Hob Cutter with Module m1
